2007-2018 Jeep Wrangler JK 2007-2018 Yeti XD JK Drag Link No Drill Top Mount Assembly JK A Minimum Lift Height of of 3-3.5 inch (And Correct bump stop) is required for a top mount Drag link.
Track Bar Relocation Bracket Required for Top mount Drag Link to maintain proper paralled geometry track bar and drag link.
- A minimum of 17 inch wheels is recommended.
- 16 inch wheels with a maximum 4.5 back spacing might fit but not guaranteed.
- Patent Pending No Drill Reverse Taper Mount makes for a quick and easy installation without the need of drilling or altering your knuckle.
- 30mm 2-1/2 Ton ball joints designed specifically for the JL and JT.
- Steel on steel bearings provide exceptional ball joint wear resistance and robustness.
- Powder coat over E-coat for a long lasting appearance under harsh conditions.
- Large 1 1/4 inch rolled threads at tie rod adjuster and draglink ends provide significantly increased strength over the original equipment threads.
- Adjuster tube designed with right hand and left hand threads for quick and easy adjustment when installed on the vehicle.